Step-by-Step Instructions
Steps:
1. Start by cutting your printed photos or designs to fit the size of the ceramic tiles.
2. Apply a layer of Mod Podge to the ceramic tile using a foam brush.
3. Carefully place the photo or design onto the Mod Podge-coated tile and press down firmly to remove any air bubbles.
4. Allow the Mod Podge to dry completely.
5. Apply a layer of Mod Podge over the photo or design, making sure to cover the entire surface of the tile.
6. Let the Mod Podge dry and repeat this step two more times, allowing each layer to dry in between.
7. Once the Mod Podge is completely dry, spray the coasters with a clear acrylic sealer spray for added protection.
8. Cut craft felt into squares slightly smaller than the size of the ceramic tiles.
9. Use a hot glue gun to attach the craft felt squares to the bottom of each coaster.
10. Finally, attach cork or felt pads to the corners of the coasters to prevent them from scratching surfaces.
Note: Allow each layer of Mod Podge to dry for at least 15-20 minutes before applying the next layer.