Step-by-Step Instructions
1. Cut a piece of wire about 10-12 inches long.
2. Use the measuring tape to determine the desired length of your bracelet, adding an extra couple of inches for the clasp.
3. Thread your chosen beads onto the wire, spacing them as desired.
4. Once all the beads are on the wire, leave about 2 inches of wire on each end.
5. Using the round-nose pliers, create a small loop at one end of the wire to secure the beads in place.
6. Wrap the wire around the beads tightly, moving towards the other end, securing them in place as you go. Make sure the wrap is neat and tight.
7. When you reach the end, create another loop to secure the last bead.
8. Attach the clasp using jump rings to each end of the bracelet.
9. Trim any excess wire with wire cutters and tuck in any sharp ends with flat-nose pliers.
10. Your beaded wire wrap bracelet is now complete and ready to wear!