Step-by-Step Instructions
1. Start by drilling holes in the bottom of the bucket or water reservoir for drainage.
2. Connect the soil moisture sensor to the Arduino board using jumper wires.
3. Attach the water pump to the bucket or water reservoir and connect it to the Arduino board using tubing.
4. Set up the breadboard with the Arduino board and connect all the necessary components.
5. Write the code for the Arduino to read the moisture levels from the sensor and activate the water pump when necessary.
6. Upload the code to the Arduino board.
7. Test the system by placing the soil moisture sensor in a potted plant and checking if the water pump activates when the moisture levels are low.
8. Adjust the code and sensor placement as needed to ensure accurate moisture level readings and watering.
9. Once everything is working correctly, secure the components in place using screws or adhesive.
10. Connect the system to a power supply and place it near your plants for automated watering.