1. Measure and cut four shelf boards from the 1x3 pine at these lengths for visual balance: 18", 22", 26", and 30".
2. Cut four small strips from the 1x3 pine, about 1" wide and the same length as each shelf, to serve as the front lip.
3. Using the chop saw, cut one end of each front lip strip at a 45-degree angle to create a mitered corner if desired for a more refined look; the other end remains square.
4. Sand all cut boards and lip pieces thoroughly with 120 grit, then 220 grit sandpaper for smoothness.
5. Attach the front lip to the front edge of each shelf board with wood glue and 1 1/4" pocket hole screws using the Kreg Jig; position the lip so it protrudes about 1/4" above the shelf surface to act as a small lip.
6. For the unique twist: cut small triangular back supports from leftover pine (about 2" tall, with a 45-degree angle) that will sit underneath the shelf at the corner where it meets the wall, providing subtle geometric detail.
7. Attach each triangular support to the underside back corner of each shelf with wood glue and screws.
8. Fill any screw holes or imperfections with wood filler and let dry.
9. Sand lightly again to smooth filled areas.
10. Stain or paint the shelves as desired; apply painter's tape on the lip for a contrasting color if desired.
11. After drying, apply 2-3 coats of clear polyurethane for protection.
12. Mark wall studs or use appropriate wall anchors.
13. Install floating shelf brackets or L-brackets inside the corner to mount shelves securely.
14. Mount shelves to walls, ensuring each corner shelf fits snugly into the corner with the triangular support visible underneath as a subtle design element.
15. Enjoy your unique floating corner shelves!